Laser Quenching equipment
Perform phase transformation hardening treatment on the metal surface to improve the hardness, wear ...
Perform phase transformation hardening treatment on the metal surface to improve the hardness, wear ...
Used for surface strengthening, repair, and remanufacturing of components, the coating has high adhe...
Flexible processing of complex curved sheet metal parts, with high cutting accuracy, fast speed, and...
Specially designed for seamless welding of precision plastic components, with a small heat affected ...
The angle steel of power towers is exposed to outdoor environments for a long time and is affected by wind and rain corrosion. The traditional hot-dip galvanized layer may peel off after 3-5 years, and maintenance requires power outages. The Daokedao automated laser cladding equipment uses Zn Al Mg zinc aluminum alloy powder to melt a 2mm anti-corrosion layer on the surface of angle steel. The cladding layer is resistant to neutral salt spray corrosion for up to 5000 hours, which is 3-4 times longer than the service life of hot-dip galvanized layers, and there is no risk of peeling when metallurgically bonded to the substrate. The application of a certain power supply bureau shows that the anti-corrosion service life of the tower angle steel after melting is expected to reach 15 years, and the anti-corrosion cost of a single base tower is reduced by 20% compared to hot-dip galvanizing. The continuous wire feeding melting technology of the equipment enables the one-time melting of 10 meter long angle steel, increasing efficiency by 50%.
